扬州NSK轴承传动系列的检修***计划

车轴使用时，应注意。我会解释一下扬州NSK轴承维护知识，希望对你们有帮助。

When the axle is used, attention should be paid to it. I will explain the knowledge of NSK bearing maintenance in Yangzhou, and I hope it will help you.

传动轴（传动轴：伸缩套筒和万向节）的***方法有哪些？

What are the maintenance methods of tran***ission shaft (drive shaft: telescopic sleeve and universal joint)?

1，对于后轮驱动车辆，驱动轴（包括轴管、伸缩套筒和万向节）与两个非等速万向节连接。如果在离合器释放开始时，在汽车底部存在噪音，或者当它加速或减速时，这意味着适配器需要更换。

1. For rear-wheel drive vehicles, the drive shaft (including axle tube, telescopic sleeve and universal joint) is connected with two non-c***tant speed universal joints. If there is noise at the bottom of the car at the start of the clutch release, or when it accelerates or slows down, this means that the adapter needs to be replaced.

2，拆下驱动轴、摇臂轴（扬州NSK轴承、伸缩套、万向节）。如果旋转角度大于45度，则不等速接头之间的间隙太大。

2, remove the drive shaft, rocker shaft (Yangzhou NSK bearing, telescopic sleeve, universal joint). If the rotation angle is greater than 45 degrees, the gap between the unequal speed joints is too large.

3，扬州NSK轴承轴驱动轴的驱动轴由轴管、伸缩套筒和万向节组成。连接器在连接部分用橡胶套筒密封。车主必须定期检查橡胶套的状况。一旦损坏，砂将进入万向节，以加速磨损（基本类型零件的失效），并降低预期寿命。

3, the drive shaft of Yangzhou NSK bearing shaft is composed of axle tube, telescopic sleeve and universal joint. The connector is sealed with a rubber sleeve in the connection part. The owner of the car must check the condition of the rubber sleeve regularly. Once damaged, the sand will enter the universal joint to accelerate the wear (failure of the basic type parts) and reduce the life expectancy.

4，橡胶套断裂容易检查：如果在扬州NSK轴承轮辋和发动机底板附近发现厚油，或当方向盘被击中时，会出现断裂的声音，表明接头损坏并应更换。

4, the rubber sleeve fracture is easy to check: if the thick oil is found near the Yangzhou NSK bearing rim and the engine floor, or when the steering wheel is hit, the broken sound will appear, indicating that the joint is damaged and should be replaced.

5，车主应避免在现场碰触方向盘，这将导致万向节由于超载而缩短其预期寿命。

5, the owner should ***oid touching the steering wheel at the scene, which will cause the universal joint to shorten its life expectancy due to overloading.

传动轴（传动轴：轴管、伸缩套、万向节）的内容是什么？

What are the contents of the tran***ission shaft (drive shaft: shaft tube, telescopic sleeve and universal joint)?

传动轴（传动轴：伸缩套筒和万向节）的使用和维护如下：

The use and maintenance of tran***ission shaft (drive shaft: telescopic sleeve and universal joint) are as follows:

1，严禁使用高速档启动汽车。凭借我们在扬州NSK轴承领域的丰富经验，我们拥有各种***工程产品的开发、制造和应用所必需的知识和专长。

1, it is strictly forbidden to use high speed gear to start the car. With our rich experience in the field of NSK bearings in Yangzhou, we h***e the knowledge and expertise necessary for the development, manufacture and application of various advanced engineering products.

2，严禁离合器踏板。

2, strictly prohibit the clutch pedal.

3，严禁******。

3, overspeed overspeed is strictly prohibited.

4，应定期检查传动轴（传动轴组成：轴、伸缩套筒和万向节）工作状态。

4, periodic inspection of the tran***ission shaft (tran***ission shaft composition: shaft, telescopic sleeve and universal joint) working state.

5，检查扬州NSK轴承传动轴悬挂架（轴、伸缩套、万向节）紧固、支撑橡胶损坏、传动轴松动连接、传动轴变形等。

5, check Yangzhou NSK bearing shaft hanging hanger (shaft, telescopic sleeve, universal joint) fastening, support rubber damage, tran***ission shaft loosening connection, tran***ission shaft deformation and so on.

6，为了保证驱动轴的动态平衡（驱动轴组成：扬州NSK轴承轴管、伸缩套筒和万向节），始终注意平衡垫是否被焊掉。

6, in order to ensure the dynamic balance of the driving shaft (the drive shaft composition: the Yangzhou NSK bearing shaft tube, the telescopic sleeve and the universal joint), always pay attention to whether the balance pad is welded or not.

文章来自：扬州SKF轴承 www.wh-skf.com

The article comes from: Yangzhou SKF bearing www.wh-skf.com

文章来自：扬州INA轴承 www.ina-china.cn

The article comes from: Yangzhou INA bearing www.ina-china.cn

文章来自：扬州NSK轴承 www.klbbearings.com

The article comes from: Yangzhou NSK bearing www.klbbearings.com

***：524085168  

电话：0510-81207777

手机：13311666672